These are the most advanced and efficient injector line heaters currently available.
However, research and development of injector line heating technology continues. Please
check back for improvements and accessory products such as solid state temperature
controls, and high temp line heater insulative jackets. Custom kits for small high MPG
engines should also be available in the near future.
Currently there are a limited number of units available as demand exceeds production
capability.
Since quality is my highest concern, I cannot raise production levels beyond the point
where product quality may suffer. As a result delivery may take up to 3 weeks from the
time you order them.
The cost is $12.00 per unit with no additional shipping
charges.
If you are a resident of MN please use THIS LINK to
go to your order page or the tab at the top of the page.
All others can get to the order page by clicking HERE or by using
the tab at the top of the page.
Product specifications:
Current draw = 12VDC/3 amps
Length of line required per heater = 3.5" to 5" depending on line
diameter.
Wire lead length = 6.25"
Maximum Btu output = 120
One heater is used per injector.
They are self adhesive and are wrapped in a spiral around the injector line as close to
the injector as possible. Complete installation directions are included with each order.
In addition to the line heaters themselves a common 12vdc automotive relay, some light
gauge insulated wire, and a switch are required for installation. A complete installation
kit will be available soon which contains everything required to install your line heaters
in a car or light duty diesel truck, but all of the parts needed to do this are commonly
available from local auto parts and hardware stores.
